Birdman1 goes UNISENS-E TELEMETRY to futaba
This is the product that we use :
https://www.sm-modellbau.de/UniSens-E-und-Zubehoer
it exist with different connections but all have the same function
this is a english manual : http://www.f5b.co.uk/wp-content/uploads/2016/01/Unisens-E-v1.11-english.pdf
this is my add on to that manual
for starters :our tools
Unisens-E
USB link Unisens
pc Programm : https://www.sm-modellbau.de/PC-Software
start the program
make connection with the usb link
check the com port and make sure that you select the correct one
push the connection button
for FUTABA : select FUTABA
FOR OTHERS CHECK THE LIST
Adjust the different options and CONFIRM your choice
check if everything got stored!
next step
tools: in my case T18SZ FUTABA
S7008R RECEIVER THAT IS ALREADY BIND TO TRANSMITTER IN THE CORRECT PROGRAM
Bec and batt supply ( or one can use a standard receiver battery)
Prepare your transmitter to the correct plane / heli / multi program
connect (on the back of your transmitter ) the Unisens-E with the proper servo connection
go to menu "linkage menu"
continue to menu "Sensor"
below the screen where you end up
go to page 3/3
THIS IS WHAT YOU SEE ON PAGE 3/3
TAB the "REGISTER" button
when everything is okay you get the following message
Tab the "REGISTER " button again
And again
until you get the message below, now all sensors are registered !
go back to the first tab 1/3
if everything went okay then you have now the following screen
return to the standard menu and select "telemetry"
and check tab 1/2
and tab 2/2
following step
connect the Unisens-E to the Sbus 2 position on the receiver
this is how my present setup looks
the second servo connector with single wire can be used depending on your transmitter but is no must.
Once connected you should get this